testexam23 
We have updated Cisco 300-425 ENWLSD dumps this month. As you prepare for the Cisco Designing Cisco Enterprise Wireless Networks (ENWLSD) 300-425 exam, you will certainly have concerns about the exam mode, question type, question difficulty.
These updated Pass4itSure 300-425 ENWLSD dumps will help you dispel these doubts and prepare everything for the 300-425 exam.
The best way to pass the Cisco ENWLSD 300-425 exam is to continuously challenge and improve your knowledge by providing the correct questions and answers through the updated Cisco 300-425 ENWLSD dumps https://www.pass4itsure.com/300-425.html 120+ Real exam questions and answers.
Get real Cisco 300-425 exam questions (1-13 of 120) check free 300-425 dumps:
1
An engineer performs a Layer 1 survey by using Metegeek chanalyzer only on the current operating channel. Which
operating mode is configured for a Cisco CleanAIR AP?
A. Local
B. Sniffer
C. Monitor
D. SE-connect
Correct Answer: A
Reference:
2
During a client roaming event, which device is responsible for communicating the new Layer 2 EID mapping of a
wireless supplicant to the fabric domain?
A. WLC
B. BN
C. CP2
D. CP1
Correct Answer: A
3
A network engineer needs to create a wireless design wired IP surveillance cameras in the parking lot through a mesh
AP. To which operate mode of the AP should the cameras connect?
A. Flexconnect
B. MAP
C. RAP
D. Local
Correct Answer: C
4
Refer to the exhibit.
An enterprise is using wireless as the main network connectivity for clients. To ensure service continuity. a pair of
controllers will be installed in a datacentre. An engineer is designing SSO on the pair of controllers. What needs to be
included in the design to avoid having the secondary controller go into maintenance mode?
A. The Keep alive timer is too low. which causes synchronization problems.
B. The connection between the redundancy ports is missing.
C. The redundancy port must be the same subnet as the redundancy mgmt.
D. The Global Configuration of SSO is set to Disabled on the controller.
Correct Answer: D
Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-7/High_Availability_DG.html
5
An engineer is designing a new wireless network. The network needs to meet these requirements:
Which design approach should be taken?
A. 5 GHz frequency band with channel bonding, to support 40 MHz channels
B. 5 GHz frequency band without channel bonding, to support 20 MHz channels
C. 5 GHz frequency band with channel bonding, to support 80 MHz channels.
D. 2.4 GHz frequency band without channel bonding, to support 20 MHz channels
Correct Answer: D
Reference: https://www.cisco.com/c/en/us/support/docs/wireless/4400-series-wireless-lancontrollers/108184-config-802-11n-wlc.html
6
A customer is looking for a network design with Cisco Hyperloctation using AP4800 for location tracking via a custom
mobile app Issues appeared in the past with refresh rates for location updates. What needs to be implemented to meet
these requirements?
A. Cisco CMX SDK in the location app
B. redundant CMX and fetch location in round-robin fashion.
C. device Bluetooth via the app
D. Cisco FastLocate technology
Correct Answer: D
7
A rapidly expanding company has tasked their network engineer with wirelessly connecting a new cubicle area with
Cisco workgroup bridges until the wired network is complete. Each of 42 new users has a computer and VoIP phone.
How many APs for workgroup bridging must be ordered to keep cost at a minimum while connecting all devices?
A. 4
B. 5
C. 6
D. 7
Correct Answer: A
Reference:
So, each AP will have 25 clients. Minimum 4 APs are sufficient.
8
A wireless engineer is performing a post verification of a wireless network. Which two metrics does the engineer verify
to ensure that the wireless network can support voice services? (Choose two.)
A. The coverage area must have a noise floor that does not exceed-87 dBm.
B. The client device must have at least an-67 dBm RSSI.
C. The rate of retransmitted packets must be 15 percent or below.
D. The rate of retransmitted packets must be 20 percent or below.
E. The client device must have at least an-65 dBm RSSI.
Correct Answer: BD
Reference:
9
An engineer has configured guest anchoring for a newly created SSD however, the mobility tunnels are not up, and
EPING is failing from the foreign WLC to the anchor WLC. Which traffic flow must be allowed at the firewall to enable
the communication?
A. UDP port 16666
B. IP protocol 97
C. UDP port 97
D. TCP port 97
Correct Answer: A
Reference:
10
How should the concept of mobility domains and mobility groups be explained to a customer?
A. WLCs do not need to be in the same mobility domain to communicate with each other Mobility groups constrain the
distribution of security context of a client and also constrain AP fail-over between controllers.
B. A mobility group does not constrain the distribution of security context of a client and also does not constrain AP failover between controllers when the WLCs are in the same mobility domain.
C. if WLCs are in same mobility domain, they communicate with each other. Mobility groups constrain the distribution of
security context of a client and also constrain AP fail-over between controllers.
D. If WLCs are in the same mobility domain, they communicate with each other but. if an anchor WLC ?present, it must:
be in the same mobility domain for communication to be possible.
Correct Answer: C
11
An engineer is conducting a Layer 2 site survey. Which type of client must the engineer match to the survey?
A. best client available
B. phone client
C. normal client
D. worst client available
Correct Answer: D
12
An engineer is reducing the subnet size of the corporate WLAN by segmenting the VLAN into smaller subnets. Clients
will be assigned a subnet by location. Which type of groups can the engineer use to map the smaller subnets to the
corporate WLAN?
A. WLC port groups
B. RF groups
C. AP groups
D. interface groups
Correct Answer: C
Reference:
13
An engineer is using a Cisco AIR-2702i AP to conduct a Layer 1 site Survey, which mode is selected for the AP to
discover non-Wi-Fi interference with metageek chanalyzer?
A. FlexConnect
B. Sniffer
C. Monitor
D. SE-connect
Correct Answer: D
More questions at Pass4itSure.
Free 300-425 PDF demo for the 300-425 exam questions:
[Google Drive] free online download: https://drive.google.com/file/d/1Zn7b1pXb1micEVSTkkX6XWD8_TlPWSzj/view?usp=sharing
Why Pass4itSure 300-425 dumps are trusted exam questions and answers?
Pass4itSure is always up to date and is truly effective 300-425 dumps: https://www.pass4itsure.com/300-425.html to help you pass the Cisco CCNP ENWLSD 300-425 exam.
You can now use Pass4itSure to provide updated 300-425 dumps VCE and 300-425 dumps PDF practice materials to help you easily study and successfully pass the exam.